To Add Target Devices To The Scan List - Avocent DSR1021 Installer/User Manual

To add target devices to the Scan list:

1. If the OSCAR interface is not open, press
appear. See Figure 3.1 on page 21 for an illustration of the Main dialog box populated with
sample data.
2. Click Setup - Scan to open the Scan dialog box. Figure 3.11 shows the Scan dialog box
populated with sample data.
Figure 3.11: Scan Dialog Box
3. Determine the order within the list to add the target device. If there are no target devices in the
Scan list, the cursor will appear in a blank line at the top of the list.
-or-
To add a target device to the end of the list, place the cursor in the last target device entry and
press the
Down Arrow
-or-
To add a target device within an existing list, place the cursor in the line below where you want
to insert a new target device and press
4. Type the first few characters of a target device name or port number to scan. The first matching
target device will appear in the line.
-or-
Press the following keyboard commands in the Name, Port or Time column to move through
the list of target devices available to scan.
Print Screen
key.
.
Insert
Chapter 3: Local Port Operation
to open the Main dialog box will
35