Advertisement
TROUBLESHOOTING GUIDE
Q.
What should I do if Auto Cleaner doesn't move or movement is very
slow?
A.
1.
Pull the cleaner's hose and lift auto cleaner off from the wrinkles.
2.
Check the circulation line:
i.
Ensure the filter pump is turned on.
ii.
Ensure the plunger valves are opened.
iii.
Clean or replace cartridge.
iv.
If using a sand filter, ensure the sand media is clean by
backwashing it.
Q.
What should I do if Auto Cleaner lifts off from the pool floor?
A.
Release air from the auto cleaner by following the "Owner's Manual".
Q.
What is the easiest way to carry the Auto Cleaner out from the pool
after used?
A.
Release the water inside the auto cleaner by following the steps below:
1.
Make sure the filter pump is turned off, and disconnect the power
cord from the electrical outlet.
2.
Pull the cleaner's hose slowly and lift the auto cleaner up just right
below the water surface.
3.
Hold the hose with one hand, and lift the auto cleaner up slowly
with an angle (either head or tail up) by carrying the cleaner
bottom with another hand.
4.
After the water has been fully released from the auto cleaner,
carry the auto cleaner out with both hands.
which could be damaged.
Q.
What should I do if the Auto Cleaner can not pick up the leaves from
the pool floor?
A.
1.
Remove the brushes from the underside and put the Auto Cleaner
back into the pool.
2.
Clean all the debris from the Auto Cleaner after running for 2-3
hours continuously.
If you continue to experience difficulty, please contact our Consumer
Service Department for assistance. See separate "Authorized Service
Centers" sheet.
S AVE THESE INSTRUCTIONS
(100PO) AUTO CLEANER ENGLISH SIZE: 4.875" X 7.25" PANTONE 295U 07/26/2012
IMPORTANT
English
DO NOT lift the hose
Page 9
100
PO
Advertisement
