Yueming CMA1325 Owner's Manual page 50

At ex-factory, the machine has calculated the pulse, please do not modify
unless you know the meanings of parameter, or it will lead the axis motion not
Attention right or the size of processing graph wrong.
The pulse parameter of No.3 controller is in the motion parameter of machine parameter,
the unit is pulse/mm, means the pulse number which sent out from control system every one
mm the motion axis go forward,. At the same time, you can modify the correlative parameter
directly through the control panel of No.3 controller as follow:
Fig.3-25 Motion parameter setting interface of No.3 controller
After modify the motion parameter of No.3 controller through the above interface, "write"
it to No.3 controller through network and restart the system. You must make sure the network
communication is normal. If the machine haven't connect the network, you can export the
parameter file of system to the U-disk, and then copy the parameter file to No.3 controller
through the U-disk, restart the system.
In addition, you can modify the correlative motion parameter in the system parameter
setting interface directly through the control panel of No.3 controller, and then restart the
system to finish as follow:
Set technics para
Set working para
Set manual para
Set system parameters
Fig.3-26 set the motion parameter through the control panel directly
X 轴行程：1600.0
Y 轴行程：2500.00
Con X: 160.00
Con Y: 160.00
- 40 -