Operation Panel - Yueming CMA1325 Owner's Manual

power supply of machine will be switched off after you press the stop button, the machine stay
at "stop" status.

After press the stop button, the system will switch off all the dynamic
power supply (e.g. machine power supply and laser power supply),
Attention
controlled power supply is still electrifying. Necessarily, if you want to
switch off the power supply of the whole machine, you should turn off
the switch of total power supply even pull out the electric cable of total
power supply.

You can loosen the stop button and continue to operating only when
the emergency has been removed and all the flaws have been rectified
or the breakdown has been restored.

After get rid of the emergency, reset the stop button by rotating
clockwise to relieve stop.
Note

You should restart the software to restore the machine to work after
relieve stop.

3.2.3 Operation panel

Control panel is mainly control the power on/off of every model of machine and operate the
machine, including control panel, emergency stop button, power switch of movement system
and key switch. The inner indicator light of some buttons indicates the current power on status
of machine.
Due to different controller, the control panel of NestCutting series machine is different.
Presently, No.3 controller and No.4 controller are collocated. Please refer to 1.2.2 about the
frame and shape of every control panel. The following is the detail of every controller. The
standard config of CMA1325 is No.3 controller, the operation panel is shown as follow:
Fig.3-15 Emergency stop button
- 33 -