Software And Machine Drive Installation - Yueming CMA1325 Owner's Manual

If your power supply system is not with an earthing, it is a must for you to have professional
electric equipment installer mount a safety earthing net in the following method:

It is a must to use 2-4 pieces of 4×35×1500mm angle iron hammered into any wet
place surrounding the house as earthing. Distance between each two angle iron is 1m.
And then use a 3×30mm flat plate leads each angle iron out from earth surface to form
a good earthing net.

After completing the earthing net, measure earthing resistance with an apparatus, the
standard value is 3-5 ohm.

After measuring the resistance, connect one end of the RVV2.5mm
to the eduction of the earthing net, one end is connected to the earthing of the carving
machine and earthing hole of the socket as shown in the figure below:

3.1.4.7 Software and machine drive installation

The controllers of NestCutting series machine: No.3 controller and No.4 controller. No.3
controller is the built-in control system; it can run independently without computer and do not
need to install any driver. No.4 controller is the athletic controller of PCI bus-mastering, you
should insert it to the computer to running, and you should install the driver progress of
controller before using. For the No.4 controller, we equip a special control table (including
computer), the operation system (Windows XP) and machine driver have been installed
at-ex-factory. If you want to install again, please follow the following principles:

The operation system, software and driver of machine have been installed and
debugged at-ex-factory. Please do not install again if the necessary instance;

The machine has mirrored the system at-ex- factory; it can be restored by one key. If
users want to install the operation system again, try to restore by one key first.

At- ex-factory, the machine has backup the installation bag of correlative software
(SmartcarveInstall4.X.X.exe file), system parameter (config.xml file) and driver progress
of controller, please do not delete.

The installation and config of the software and driver, please to Han's YM User Manual
of NestCutting.
Earthing
terminal
Fig.3-13
- 31 -
2
copper core cable