Service Factory Mode - Pioneer PRO-141FD Service Manual

5

6. SERVICE FACTORY MODE

6.1 OUTLINE OF THE SERVICE FACTORY MODE
Operations during Service Factory mode are described here.
[1] TRANSITION DIAGRAM OF SERVICE FACTORY MODE
Remote control unit: POWER key
RS-232C command: POF
Power-on mode
< Normal mode >
• Change in functions
• Change in Signal modes
Remote control unit: FACTORY key
RS-232C command: FAY+FAC S00
or FAY+PFM S00
< Factory mode >
"CH Up" or "CH Down" key
Note: The FACTORY MENU starts with "6.2 [1-11] PANEL FACTORY".
[2] HOW TO ENTER/EXIT SERVICE FACTORY MODE
How to enter Service Factory Mode
By using a PDP service remote control)
• PDP service remote control
• Supplied remote control unit
By issuing RS-232C commands )
• During normal Standby mode
• During normal operation mode : Issue [FAY] then [FAC S01].
How to exit Service Factory Mode
By using a PDP service remote control)
• PDP service remote control
• Supplied remote control unit
By issuing RS-232C commands)
• Issue [FAY] then [FAC S00] + [FAN].
5
6
Standby mode
Remote control unit: POWER key
RS-232C command: PON
Remote control unit: FACTORY key
RS-232C command: FAY+FAC S01
FACTORY MENU
"ENTER" key in page 11
of FACTORY menu
PANEL FACTORY
: Press [FACTORY] key.
: This model, can not enter the Service Factory Mode
by operating the supplied remote control unit keys.
: Issue [PON] then [FAY] + [FAC S01].
: press [FACTORY] key.
: Press the POWER key to enter Standby mode then press the POWER key again
to turn the unit on.
PRO-141FD
6
7
or FAY+PFM S01
7
8
A
B
C
D
E
F
139
8