Table of Contents
Advertisement
Verify
Verify the Product's data plate label, attached to one side of the Product, to ensure that
the technical details actually meet your needs (main supply voltage, charger capacity,
etc.).
INSTALLATION INSTRUCTIONS
The charger is attached using 4 x #8 (4mm Ø) screws (not supplied), to a secure
mounting frame or wall.
Ideally, the charger should be in a vertical position, with the cable outlet pointing
downwards. Clearance of at least 4" (10 cm) must be allowed around the device to
guarantee optimum convection, in particular along the sides allowing the air needed
for ventilation to flow in and out.
The circulation and convection direction of the air inside the charger is from right to left,
viewed from the front of the Product.
CONNECTIONS
Ventilation direction
Warm
CONNECTIONS
To gain access to the charger's connections, the front cover must be removed. To do
this, simply unscrew the screw on the front cover. The cover is removed by rotating it.
Prior to making connections, the main power cable gland must be positioned and
attached to the housing in the hole designed for this purpose (hole on the left, when
viewed from the front of the charger).
The plastic nut supplied with the cable gland allows it to be attached to the housing.
This nut is positioned on the inside of the housing. Ensure the correct tightening torque
is applied.
on the housing prior to connection).
The battery temperature sensor (24V100A version only)
←←←
Cool
6
Advertisement
Table of Contents
