Operation Instructions - Sentry Voyager Series Installation & Operation Manual

OPERATION INSTRUCTIONS

MODE
Boost
Equalize
End of
Equalization
Floating
Internal
Temperature
Fault
Output
voltage fault
Battery fuse
fault
"Night"
mode
12V-25A
12V-40A
24V-20A
LED
Steady
Yellow
(1)
Yellow
Blinking
(2)
Green
Blinking (3)
Green (4)
Red
Fixed
(5)
Red
Blinking
(6)
Red
Flashing
(7)
STATUS
The batteries are charging. Time required to complete
Boost mode varies depending on the initial status of the
batteries, but is limited to 6 hours.
The batteries are coming to the end of the
charging cycle. Time required to complete
Equalization mode, depending on the initial status
of the batteries, varies from 30 minutes to 4 hours.
The batteries are almost charged.
Floating mode will begin in less than 30 minutes
The batteries are completely charged.
The charger is on Standby for a period of between
30 seconds and 10 minutes. Once the fault has
been solved, the device will start up again
automatically.
If this problem arises, please check the external
temperature sensor as well as the internal fan and
the space around the charger.
The charger is on Standby for a period of 30
seconds. Once the fault has been solved, the
device will start up again automatically.
The problem may be the PC Board has failed and
the damage is irreversible.
The fuse should be replaced.
Please check all connections as well as the
battery's polarity and status.
This mode allows the charger to work without
noise (from the fan). In this case, charging levels
adapt. To activate this mode, press the button for
about 2 seconds. To deactivate, a simple press of
the button or the mode deactivates automatically
after 10 hours
8