Table of Contents
Advertisement
Perform the following steps to mount the RackSwitch G8124 into a standard 4-post rack.
1.
Use the M4 screws to attach a horizontal rail to each side of the switch.
Torque the screws to approximately 10 inch-pounds (1.1 Nm).
2.
M6 screws, washers, and clip nuts are used to connect the horizontal rail to the front posts in the
rack. Torque the screws to approximately 30 inch-pounds (3.5 Nm).
30
BNT RackSwitch G8124 Installation Guide
Figure 10
Attaching the Horizontal Rail
Figure 11
Rack-Mounting the Switch Unit
Advertisement
Table of Contents
