Table of Contents
Advertisement
2.
M6 screws, washers, and clip nuts are used to attach the alignment plate.
Torque the screws to approximately 30 inch-pounds (3.5 Nm).
3.
M6 screws, washers, and clip nuts are used to mount the switch unit into the rack.
Torque the screws to approximately 30 inch-pounds (3.5 Nm).
28
BNT RackSwitch G8124 Installation Guide
Figure 8
Attaching the Alignment Plate
Figure 9
Rack-Mounting the Switch Unit
Advertisement
Table of Contents
