Integra DRX-R1.1 Basic Manual page 59

> Specifications > Advanced Setup
■ 2. Network
• When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the
setting automatically. ("Enable" is set by default) To assign fixed IP addresses to each
components, you must set "DHCP" to "Disable" and assign an address to this unit in
"IP Address" as well as set information related to your LAN, such as Subnet Mask and
Gateway.
Setting Item Default Value
-
MAC Address
DHCP Enable
IP Address 0.0.0.0
Subnet Mask 0.0.0.0
Gateway 0.0.0.0
DNS Server 0.0.0.0
-
Proxy URL
Proxy Port 8080
> Listening Modes > Network Functions
Setting Details
This is the MAC address of this unit.
This value is specific to the component and cannot
be changed.
"Enable": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
• If selecting "Disable", you must set "IP Address",
"Subnet Mask", "Gateway", and "DNS Server"
manually.
Displays/Sets the IP address.
Displays/Sets the subnet mask.
Displays/Sets the gateway.
Displays/Sets the primary DNS server.
Displays/Sets the proxy server URL.
Displays/Sets the proxy server port number when
you enter "Proxy URL".
Troubleshooting
Setting Item Default Value Setting Details
Friendly Name Integra Change the device name for this unit which is
DRX-R1.1 shown on other devices connected to the network
XXXXXX to an easily recognized name.
1. Press Enter to display the Edit screen.
2. Select a character or symbol with the cursors
3. After inputting, select "OK" with the cursors and
> Basic Manual
| Supplementary Information, etc.
and press Enter.
Repeat it to input 31 or less characters.
"A/a": Switches between upper and lower
cases. (Pressing Mode on the remote
controller also toggles between upper and
lower cases.)
"←" "→": Moves the cursor to the arrow
direction.
" ": Removes a character on the left of the
cursor.
" ": Enters a space.
• Pressing Clear on the remote controller will
remove all the input characters.
press Enter.
The input name will be saved.
23