Integra DRX-R1.1 Basic Manual page 13

> Before Start > Part Names
Speaker combinations
0 In any of the combinations, up to two powered subwoofers can be connected.
Speaker
Channels FRONT
2.1 ch
3.1 ch
4.1 ch
5.1 ch
6.1 ch
7.1 ch
2.1.2 ch
3.1.2 ch
4.1.2 ch
5.1.2 ch
6.1.2 ch
7.1.2 ch
4.1.4 ch
5.1.4 ch
6.1.4 ch
7.1.4 ch
Points to note with speaker combinations
(*1) It is not possible to use Bi-AMP and ZONE speakers at the same time. However, with 2.1 ch to 7.1
ch, it is possible to use Bi-AMP and ZONE 2 speakers at the same time.
(*2) If front speakers are to be Bi-Amping connected, height speakers need to be connected to the
HEIGHT 2 jacks.
(*3) ZONE 2 speakers need to be connected to the HEIGHT 1 jack, ZONE 3 speakers need to be
connected to the SURROUND BACK jacks, and height speakers need to be connected to the
HEIGHT 2 jacks.
> Install > Initial Setup
SURROUND
CENTER SURROUND
> Playback
BACK HEIGHT 1 HEIGHT 2
(*2)
(*2)
(*2)
(*2)
(*2)
(*2)
HEIGHT 1/HEIGHT 2
When connecting 2 sets of height speakers, the height speaker combinations you can choose are as
follows.
– Height 1 Speaker: Top Middle, Height 2 Speaker: Rear High
– Height 1 Speaker: Front High, Height 2 Speaker: One of Rear High/Top Middle/Top Rear/Dolby
Enabled Speaker (Surround)/Dolby Enabled Speaker (Surround Back)
– Height 1 Speaker: Top Front or Dolby Enabled Speaker (Front), Height 2 Speaker: One of Rear High/
Top Rear/Dolby Enabled Speaker (Surround)/Dolby Enabled Speaker (Surround Back)
When connecting only one set of height speakers, select one type of height speakers from the types
available.
> Advanced Manual
Troubleshooting | Supplementary Information, etc.
ZONE 2 (*1) ZONE 3 (*1)
(ZONE SPEAKER) (ZONE SPEAKER)
Bi-AMP (*1) (P22) (P23)
(*3)
(*3)
(*3)
(*3)
13
En