Integra DRX-R1.1 Basic Manual page 48

> Specifications > Advanced Setup
Setting Item Default Value
Height 1 Speaker Top Front
12
> Listening Modes > Network Functions
Setting Details
Set the speaker type if height speakers are
connected to the HEIGHT 1 terminals. Select
"Front High", "Top Front", "Top Middle", "Top
Rear", "Rear High", "Dolby Speaker (Front)",
"Dolby Speaker (Surr)", or "Dolby Speaker (Back)"
according to the type and layout of the connected
speakers.
• This setting cannot be selected under any of
following conditions. Set the height speakers
type to "Height 2 Speaker".
– "Bi-Amp" is set to "Yes"
– "Zone Speaker" is set to "Zone 2/Zone 3"
• When two sets of height speakers are being
used, "Top Rear", "Rear High", "Dolby Speaker
(Surr)", and "Dolby Speaker (Back)" cannot be
selected.
• "Dolby Speaker (Surr)" and "Dolby Speaker
(Back)" can only be selected when surround
speakers or surround back speakers are being
used, respectively. You can check speakers
that you are using on the figure displayed in
"Speaker Channels".
• If an item cannot be selected even though
connection is correct, check that the settings
in "Speaker Channels" matches the number of
connected channels.
Troubleshooting
Setting Item Default Value Setting Details
Height 2 Speaker Top Rear Set the speaker type if height speakers are
connected to the HEIGHT 2 terminals. Select
"Front High", "Top Front", "Top Middle", "Top
Rear", "Rear High", "Dolby Speaker (Front)",
"Dolby Speaker (Surr)", or "Dolby Speaker (Back)"
according to the type and layout of the connected
speakers. However, the options selectable for the
"Height 1 Speaker" the are as follows.
If "Height 1 Speaker" is set to "Front High": Select
from "Top Middle", "Top Rear", "Rear High", "Dolby
Speaker (Surr)", or "Dolby Speaker (Back)".
If "Height 1 Speaker" is set to "Top Front" or "Dolby
Speaker (Front)": Select from "Top Rear", "Rear
High", "Dolby Speaker (Surr)", or "Dolby Speaker
(Back)".
If "Height 1 Speaker" is set to "Top Middle": Fixed
to "Rear High".
Zone Speaker No Set the connection of speakers to Zone 2 or Zone
3 speaker terminals.
"Zone 2": When speakers are connected only to
Zone 2 speaker terminals
"Zone 2/Zone 3": When speakers are connected to
both Zone 2 and Zone 3 speaker terminals
"No": When speakers are not connected to either
speaker terminals
> Basic Manual
| Supplementary Information, etc.
• "Dolby Speaker (Surr)" and "Dolby Speaker
(Back)" can only be selected when surround
speakers or surround back speakers are being
used, respectively. You can check speakers
that you are using on the figure displayed in
"Speaker Channels".
• If an item cannot be selected even though
connection is correct, check that the settings
in "Speaker Channels" matches the number of
connected channels.
• "Zone 2/Zone 3" cannot be selected when
surround back speakers and height speakers
are being used.
• This item will be set to "No" when two sets of
height speakers are being used.