Cisco Mds 9500: Disabling Fcoe - Cisco Nexus 7000 series Configuration Manual

Disabling FCoE
Command or Action
Step 5
exit
Example:
switch(config-vdc)# exit
switch(config)#
Step 6 no install feature-set fcoe
Example:
switch(config)# no install feature-set fcoe
Step 7
show feature-set
Example:
switch(config)# show feature-set
Step 8
copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config

Cisco MDS 9500: Disabling FCoE

After you disable the FCoE feature, all FCoE commands are removed from the CLI and the FCoE configuration
is deleted.
SUMMARY STEPS
1. configure terminal
2. no feature-set fcoe
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2 no feature-set fcoe
Example:
switch(config)# no feature-set fcoe
Cisco NX-OS FCoE Configuration Guide for Nexus 7000 and MDS 9500
14
Purpose
Exits VDC configuration mode.
Uninstalls the FCoE feature set. Use this command in the
default VDC after you disable the FCoE feature set.
(Optional)
Displays information about the feature sets.
(Optional)
Copies the running configuration to the startup configuration.
Purpose
Enters configuration mode.
Disables the FCoE feature set. The no feature-set fcoe command
may take some time to complete if the size of the configuration is
very large. The command must clean up all of the configuration
associated with the FCoE feature set.
FCoE
OL-25809-02