Air Cleaner - WACKER Group PT 6LT Operator's Manual

Maintenance
5.4

Air Cleaner

See Graphic: wc_gr003175
5.4.1
5.4.2
5.4.3
5.4.4
b
wc_tx000567gb.fm
Inspect the air cleaner and change the oil in the oil bath daily before
starting the engine. In dusty conditions, check the condition of the oil
in the air cleaner several times during the day. Change the oil if it
appears thick or gritty. Clean the air cleaner often.
Keep the oil bowl filled with clean oil up to level mark (a).
NOTICE: NEVER run the engine without oil in the air cleaner! Severe
engine damage will result.
To clean the air cleaner:
Release the snap clips (b) and remove the oil bowl (c).
Remove the filter element (d) from the oil bowl. Be careful not to
damage the rubber seal ring (e) on the element.
Rinse the filter element with diesel fuel or kerosene. DO NOT use
gasoline. Allow the filter element to air dry completely.
Change the oil in the oil bowl. Fill the oil bowl to the level mark (a).
Place the filter element in the oil bowl and install the oil bowl on air the
cleaner.
l
O i
a
30
PT 6 /...
d
e
c
wc_gr003175