Table of Contents
Advertisement
426
Description
Selection
Default
Programming
Conditions
Feature References
22
4.6
CO Line Programming
ISDN Configuration
Assigns the configuration on ISDN port basis. This program is
available for ISDN extension only.
• Port number: KX-TD816—01 through 06,
KX-TD1232—01 through 12,
• Point (point to point) / Multipoint (point to multipoint)
• KX-TD816 Port 05 and 06– Multipoint; other ports–Point
• KX-TD1232 All ports – Point
1.
Enter 426.
Display: Access Mode
2.
Press NEXT.
Display: Port NO?–>
3.
Enter a port number.
To enter a first port number, you can also press NEXT.
Display example: #01:Point
4.
Keep pressing SELECT until the desired selection is
displayed.
5.
Press STORE.
6.
To program another port, press NEXT or PREV, or
SELECT and the desired port number.
7.
Repeat steps 4 through 6.
8.
Press END.
• For the KX-TD1232, port numbers 01 through 06 are for the Master
System and 07 through 12 are for the Slave, if available.
• If one equipment is connected to the ISDN port, select "Point." If
multiple equipments are connected, select "Multipoint."
• To assign all ports to one selection, press the
case, the display shows the contents programmed for a first port.
• After this assignment, you should reset the system so that this
assignment is effective.
None
(
=all ports)
(
=all ports)
key at step 3. In this
Advertisement
Table of Contents
