Mounting - JBL Infinity Quick Start Manual

JBL/Infinity Soundbar Quick-Start Guide
5. Before attaching the rear bridge plate, you will need to set the Input Level switch, Auto Turn‐On
switch and Gain controls:
[Insert illustration: "Control Panel_082316.ai"]
a. If you will be connecting the soundbar's audio inputs to the pre‐outs of a car stereo head unit or
other line‐level source, set the Input Level switch in the "Lo" position. If you will be connecting the
soundbar to the speaker‐level outputs of a car stereo head unit, set the Input Level switch in the
"Hi" position.
b. If you have set the Input Level switch in the "Lo" position, set the Gain control [TBD]; if you have
set the Input Level switch in the "Hi" position, set the Gain control [TBD]. After you complete the
installation and begin using your soundbar you can fine‐tune the Gain control setting to maximize
the soundbar's performance.
c. If you want the soundbar to automatically turn on when it receives an audio signal, set the Auto
Turn‐On switch in the "On" position. If not, set the switch in the "Off" position.
6. Attach the rear bridge plate to the two speakers, using the small hex wrench and the remaining 4
bridge plate screws.
[Insert illustration: "Assembly_5_082316.ai"]
Mounting
1a. Insert the 2 mounting bracket base assemblies into the 2 mounting track openings on the bottom of
the soundbar.
1b. Slide the mounting bracket bases inside the tracks all the way around to the top of the soundbar.
[Insert illustration: "Mounting_1_082816.ai"]