Advertisement
JBL/Infinity Soundbar Quick-Start Guide
2. Position the soundbar in the desired location against the vehicle mounting bar. Use 4 of the supplied
mounting bracket bolts to secure each bracket top to a bracket base. (Two sets of bolts are supplied,
allowing the soundbar to be mounted to pipes up to XXX in diameter.)
a. When the soundbar is in the correct position, tighten the mounting bracket adjustment screws.
[Insert illustration: "Mounting_2_082816.ai]
3. Install the 2 safety harness assemblies [TBD]
Ground, Power, Illumination and Remote Connections
IMPORTANT: Disconnect the vehicle's negative (–) battery terminal before beginning the installation.
Connect the soundbar's +12V power (red), ground (black), illumination (orange) and remote turn‐on
(blue) wires as shown below.
Use sandpaper to clear the paint from the metal surface at the ground connection. Use a star‐type
lock washer to secure the connection.
Install a fuse holder for a 40A fuse on the power (12V) wire within 18" (46cm) of the (+) battery
terminal. Do not install the fuse in the holder at this time.
Advertisement
