Table of Contents
Advertisement
MEDIA CONNECTIONS: PAL / SECAM / DVB-T2
Description
Power In
12 Volt DC Power In
USB
USB Flash Drive
High-Definition Input
High-Definition Audio & Video Connection
VGA In
PC-Video Connection
Video In
Video In
Audio In
Stereo Line In
S-Video In
S-Video Signal In
RF Coaxial
Antenna / Cable Connection
Wired Remote /
Wired Remote Control Connection
Media Cable
Audio Out
Headphone Connection
10
Connector Type
Power Jack
USB Type A
High-Definition
VGA
RCA (yellow)
RCA (red and white)
S-Video
RF F-Type
Remote Control
3.5mm stereo jack, 0.3W
INSTALLATION
Models: 95T Elevation Discover SI & Explore
Tools Required: Phillips Screwdriver, Metric Allen Set, M16 & M17 Wrench
Parts Not Used From Kit: (1) Main Bracket Cap, (1) Grommet
1. Turn off the treadmill and unplug it from the power outlet.
For 95T Elevation Inspire Units Only:
1a.
Remove the six screws securing the motor cover. Remove
the motor cover and set it and the screws aside.
1b.
Remove the protective liner from one of the provided
fastener strips. Attach the fastener strip to the bottom of
the POWER BLOCK (1). Interlock the remaining fastener
strip to the installed fastener strip. Remove the remaining
protective liner from fastener strip and secure the power
block to the frame.
1c.
Plug the POWER CORDS (2) leading from the motor
compartment and left upright into their respective ends of
the POWER BLOCK (1). Feed excess cable into the left upright.
1d.
Re-install the motor cover using the six previously removed screws.
2. Attach the LOWER MOUNTING BRACKET (3) to the MAIN BRACKET (4) using four SCREWS (5) and WASHERS (6)
each. Tighten the screws securely (8-10 ft. lbs.).
3. Slide the NEW BRACKET COVER (7) over the top end of the MAIN BRACKET (4) and down to meet the LOWER
MOUNTING BRACKET (3).
4. Attach the TV BRACKET (with bent tab) (8) to the MAIN BRACKET (4) using four SCREWS (5) and WASHERS (6).
Tighten the screws securely (8-10 ft. lbs.).
4
7
8
6
5
5
6
3
11
Advertisement
Table of Contents
