Table of Contents
Advertisement
7. Install the DISPLAY CONSOLE (m) as instructed in the
Assembly Instructions using the four new SCREWS (n)
supplied. Tighten the SCREWS to 6-8 in-lbs. Do not
overtighten the SCREWS.
CAUTION: Do not pinch any wires when assembling the
DISPLAY CONSOLE (m) to the CONSOLE SUPPORT
BRACKET TUBE (c).
8. Connect the COAXIAL CABLE, POWER CORD and I-R
REMOTE CONTROL CABLE to the rear of the ATTACHABLE
TV. See the Media Connections page in this manual for
detailed information.
9. Cable tie any excess cable together behind the
ATTACHABLE TV and position the cables between the TV
MOUNTING BRACKET (g) and the DISPLAY CONSOLE (m).
10. Locate the new TOP CAP (o). Place the new top cap into
position at the top of the TV MOUNTING BRACKET (g).
Be sure the top cap snaps securely in place.
11. Secure the POWER ADAPTER (p) to the FRONT
STABILIZER (q) using two CABLE TIES (r) as shown. Be sure
the cable ties are pulled tight. Trim the excess cable ties.
Connect the SCREW-TYPE CONNECTOR of the power SUPPLY CORD (d) to the underside receptacle. Bundle any
excess POWER SUPPLY CORD and store under the unit. Connect the COAXIAL CABLE (e) to the broadcast supply
cable in similar fashion.
12. Connect the POWER SUPPLY CORD to the POWER ADAPTER (p).
13. Continue with the remainder of assembly as instructed in the Assembly Instructions. Plug the power supply cord
into an electrical outlet upon completion. See the Media Connections pages in this manual for detailed informa-
tion.
66
e
d
k
j
g
l
c
n
e
d
p
q
r
o
i
d
f
e
h
h
m
Advertisement
Table of Contents
