Table of Contents
Advertisement
6. Assemble the MATING BRACKET (q) to the back of the
ATTACHABLE TV with four SCREWS (r) and four steel
WASHERS (s).
7. Assemble the ATTACHABLE TV to the TV
MOUNTING BRACKET. Insert one HEX BOLT (t) and
WASHER (u) through both parts that make up the
hinged bracket. Partially tighten both brackets with one
LOCK NUT (v). Adjust the TV position so that the TV face
is perpendicular to the floor. Insert two SCREWS (w) to
lock the bracket position. Fasten the hinged bracket
securely.
8. Insert one end of the AUDIO / VIDEO / I-R REMOTE
CONTROL CABLE ASSEMBLY into the CONSOLE
CONNECTOR.
9. Reattach the console to the console support bracket
with the four previously removed screws in Step 2.
Tighten the screws to 6-8 in-lbs.
Connect the COAXIAL CABLE, POWER CORD, and
AUDIO / VIDEO / I-R CABLE ASSEMBLY to the rear of the
ATTACHABLE TV. See the Media Connections pages in this
manual for detailed information.
10. Re-insert the previously removed square END CAP (a) into the
top of the TV MOUNTING BRACKET.
11. Secure the POWER ADAPTER (x) to the FRONT STABILIZER (y)
using two CABLE TIES (z) as shown. Be sure the CABLE TIES are
pulled tight and trim the excess CABLE TIES. Connect the
screw-type connector of the POWER CORD (aa) to the under-
side receptacle. Bundle excess power cord and store under
the unit. Connect the COAXIAL CABLE (bb) to the broadcast
supply receptacle in similar fashion.
12. Connect the POWER SUPPLY CORD to the POWER ADAPTER (x).
13. Continue with the remainder of assembly as instructed in the Assembly Instructions. Plug the POWER SUPPLY
CORD into an electrical outlet upon completion.
40
s
r
q
w
v
u
t
y
aa
bb
bb
y
x
aa
z
Model: OSC (Activate Series)
Tools Required: Phillips Screwdriver, Metric Allen Set
1. Remove and discard the four M5 SCREWS (a) attaching the CONSOLE (b) to
the CONSOLE SUPPORT BRACKET (c). Disconnect cable connection.
2. Secure the PRIMARY TV BRACKET (d) to the CONSOLE SUPPORT BRACKET (c)
using M5 SCREWS (e) and M5 WASHERS (f).
3. Attach INTERMEDIATE BRACKET (g) to back of CONSOLE (b) using four M5
SCREWS (e) and M5 WASHERS (f). Reconnect cables.
d
f
e
c
4. Secure the CONSOLE and INTERMEDIATE BRACKET to the PRIMARY TV BRACKET using two M6 X 70 MM BOLTS
(h), four M6 WASHERS (i), and two M6 LOCK NUTS (j).
i
h
b
c
a
b
g
f
e
j
i
41
Advertisement
Table of Contents
