Model: Ost Activate Series - Life Fitness ATV15-XXXA-02 Assembly Instructions Manual

6. Attach the ATTACHABLE TV (k) to the MOUNTING BRACKET (j) using four SCREWS (l), WASHERS (m),
and SHOULDER NYLON WASHERS (n). Tighten the SCREWS to 6-8 in-lbs. Do not overtighten the SCREWS.
m
l
n
7. Connect the AUDIO / VIDEO / I-R REMOTE CONTROL CABLE (a), POWER SUPPLY CORD (b), and the COAXIAL
CABLE (c), to the rear of the ATTACHABLE TV (k). See the Media Connections pages in this manual for detailed
information.
8. Remove the motor shroud and the front cable tie.
9. Mount the POWER ADAPTER (r) inside the open space next to the motor control board using DOUBLE SIDED
TAPE. Connect the SCREW-TYPE CONNECTOR (u) of the POWER ADAPTER to the pre-wired TV POWER CABLE (v).
Bundle excess power cord and store inside the left upright. Connect the POWER SUPPLY CORD (c) to the POWER
ADAPTER (r).
10. Replace the motor shroud using the screws provided.
11. Connect the COAXIAL CABLE (c) to the broadcast supply in a similar fashion.
Note: Be sure to leave 12" of excess coaxial cable between the floor and the coaxial connection on the unit to
accommodate elevation of the unit.
12. Continue with the remainder of assembly as instructed in the Integrity Series Assembly Instructions. Plug the
POWER SUPPLY CORD into an electrical outlet upon completion.
v
u
s
r
16
k
j
c
Model: OST (Activate Series)
Tools Required: Phillips Screwdriver, Metric Allen Set, 13 mm Socket
1. Remove the four M4.2 X 19MM PHILLIPS HEAD SCREWS (a) and two #10 X 0.5" PHILLIPS HEAD SCREWS (b) that
hold the BOTTOM CONSOLE TRAY (c) . SAVE THE HARDWARE. Discard the BOTTOM CONSOLE TRAY.
2. Remove the four M5 SCREWS (d) from the CONSOLE ASSEMBLY (e). SAVE THE HARDWARE.
SAVE THE HARDWARE!
3. Disconnect the WIRE HARNESS from the console. Set the CONSOLE aside.
4. Remove the two SCREWS (g) that hold the UPPER CONSOLE TRAY (h). Set the UPPER CONSOLE TRAY aside.
SAVE THE HARDWARE.
c
a
b
SAVE THE HARDWARE!
e
d
17