Table of Contents
Advertisement
Models: 95PS-03 Discover/Explore
Tools Required: Phillips Screwdriver, Metric Allen Set, M16 & M17 Wrench
Parts Not Used From Kit: (1) Lower Mounting Bracket
1. Secure the power block (1) to the underside of the center
frame using the fastener strip.
2. Connect the Power cord (2) to the receptacle.
3. Bundle the excess power cord, and store the bundled cord
under the unit.
4. Connect the coaxial cable (3) to the broadcast supply re-
ceptacle.
5. Remove the four screws (5) that secure the rear console
cover (1) to the console frame (4).
6. Unclip, and remove the rear console cover (1).
7. Remove the four screws (3) that secure the insert (2).
8. Remove the insert (2).
9. Remove the four screws (1) that secure the console (3) to the
console frame (2).
10. Attach the TV bracket (4) to the main bracket (7) using four screws
(6) and four washers (5).
11. Tighten the screws (6). Tighten the screws (6) to 8-10 ft. lbs..
62
2
3
1
4
3
2
1
5
3
2
1
12. Pull the coaxial cable from inside of the console bracket (3).
13. Install the coaxial extension coupler and coaxial extension
cable.
14. Tape the ends of all of the cables together.
15. Feed the taped ends of all of the media cables through the
large hole in the back of the console bracket (3).
16. Side the grommet (1) over the taped end of the media
cables.
17. Feed the taped end of the media cables through the large
hole at the bottom of the main bracket assembly (4), and
route the media cables through the hole at the top of the main bracket assembly (4).
18. Side the grommet (1) over the taped end of the media cables.
19. Install both grommets (1) into the main bracket assembly (4).
20. Install the main bracket caps (1) into the top and bottom of the main
bracket assembly.
1
4
3
2
22. Place the TV bracket (2) on the attachable TV (1).
23. Place the four washers (3) on the four screws (4).
24. Install the four screws (4). Tighten the four screws (4)
to 8-10 ft. lbs..
1
2
4
21. Attach the main bracket assembly (1) to the
console bracket (2) using the screws (4) and washers (3).
Tighten the screws (4) to 8-10 ft. lbs..
3
63
Advertisement
Table of Contents
