Table of Contents
Advertisement
Chapter 3 Setup
1.
Turning on the Server
Follow the steps below to turn on the power.
1. Connect the power cord to this server and wait until the Module POWER LED on CPU/IO modules 0 and
1 start blinking green.
2. Power on the display unit and other peripherals connected to the server.
3. Remove the front bezel.
Express5800/R310e-E4, R320e-E4, R320e-M4, R310f-E4, R320f-E4, R320f-M4 User's Guide
64
Tips
It takes about one minute for LEDs on the front side of the server to turn to on or start
blinking after the power cord is connected to the server.
Module POWER
If you power off the server, wait at least 30 seconds before turning it on again.
If the power code is connected to a power controller (such as UPS), ensure that the
Note
controller is powered on.
LED
1. Turning on the Server
Advertisement
Table of Contents
