Transceiver Board Removal - Motorola MTM700 Basic Service Manual

MAINTENANCE

Transceiver Board Removal

1. Remove six screws from the diecast cover using the T20 TORX™ driver as shown in
Figure 6 - 4.
2. Lift the cover from the chassis.
3. Slowly lift the transceiver board on the edge at the front of the radio (the edge that mates with
the control head) and pull gently toward the front of the radio as shown in Figure 6 - 5. Take
care to slide the antenna connector and power connector out of the chassis towards the front.
CAUTION: The thermal pad can act as an adhesive and cause the leads of the heat
!
dissipating devices to be over stressed if the board is lifted too quickly.
If the board can't be easily lifted, the chassis must be heated up to 55 degree Celsius.
MTM700 Mobile Terminal / Basic Service Manual
Diecast
Cover
Radio
Chassis
Figure 4 Diecast Cover Removal.
Antenna
Connector
Figure 5 Transceiver Board Removal
Screws (6)
Lift
6 - 7
ZWG0130212-O
ZWG0130213-O