Standard Control Head - Disassembly - Motorola MTM700 Basic Service Manual

MAINTENANCE

Standard Control Head - Disassembly

1. To dismount the control head housing from the back housing, insert the dismantling tool in the
groove between the two housings as shown in the following Figure.
2. Press the dismantling tool until the snap connectors on the side of the back housing release
from the control head.
3. Remove the board from the control head housing by stretching the control head housing and
pulling up on the board as shown in the Figures.
4. Remove the keypad from the control head housing by lifting up the rubber keypad.
NOTE Care should be taken not to touch or contaminate the conductive pads on the under
side of the keypad or the conductive contacts on the printed circuit board.
MTM700 Mobile Terminal / Basic Service Manual
Figure 6 Control Head Back Housing Removal
Figure 7 Control Head Board Removal
Display
PCB
Keypad
Fronthousing
ZWG0130215-O
6 - 9