Testing; Reset Button - Tunstall Belle User Manual

T E S T I N G
We recommend that you test belle ® monthly.
1. To test, press and hold the call button
until the small call light on belle
2. After a short delay, you will hear tones
or ringing.
3. The Emergency Response Center Operator will
answer the call. *
4. Tell the Emergency Response Center Operator
you are testing.
R E S E T B U T T O N
The Reset button is the small circular button on the
left hand side of the device. Pressing the Reset button
will immediately terminate an in-progress call. This
action is not recommended as it limits our Operator's
ability to contact you via the device. If you accidentally
activate the belle
through and simply inform the Operator that you are
OK and no help is needed.
Important - If you accidentally press the Reset button
during an emergency call, simply press the Call button
again to initiate a new call to the Emergency Response
Center.
*If AT&T service is not available in the location where the call is placed
the device will attempt to call 911 directly using an alternate GSM cellular
service. If there is no GSM cellular coverage, the call will not be completed.
it is preferred that you let the call go
®
turns blue.
®