Table of Contents
Advertisement
1
Important Safety & Service
Notices
1.1
Safety Warnings
PoE power adapter for RDL-2000:
1.
Customer equipment including personal computers, routers, etc., must be connected
only to the INPUT (DATA) port on the PoE unit.
Only the outdoors Ethernet interface cable connecting to the unit can be safely
connected to the OUTPUT (DATA & POWER OUT) connector. Connecting customer
premises Ethernet equipment directly to the OUTPUT (DATA & POWER OUT)
connector on the Power-over-Ethernet power adapter may damage customer
equipment.
Installation of the system must be contracted to a professional installer.
2.
The installer and operator are responsible for ensuring that the system is used
3.
exclusively for fixed, point-to point operations.
Read this user manual and follow all operating and safety instructions.
4.
Keep all product information for future reference.
5.
The power requirements are indicated on the product-marking label. Do not exceed
6.
the described limits.
Disconnect the power before cleaning. Use only a damp cloth for cleaning. Do not
7.
use liquid or aerosol cleaners.
Disconnect power when unit is stored for long periods.
8.
The unit must not be located near power lines or other electrical power circuits.
9.
The system must be properly grounded to protect against power surges and
10.
accumulated static electricity. It is the user‟s responsibility to install this device in
accordance with the local electrical codes: correct installation procedures for
grounding the unit, mast, lead-in wire and discharge unit, location of discharge unit,
size of grounding conductors and connection requirements for grounding electrodes.
1.2
Warning Symbols
The following symbols may be encountered during installation or troubleshooting. These
warning symbols mean danger. Bodily injury may result if you are not aware of the safety
hazards involved in working with electrical equipment and radio transmitters. Familiarize
yourself with standard safety practices before continuing.
70-00143-01-01a
RDL-2000
Warning to Service Personnel: 48 VDC
Electro-Magnetic Radiation
Proprietary Redline Communications © 2010
User Manual
Chapter
High Voltage
Page 6 of 50
September 24, 2010
1
Advertisement
Table of Contents
