Table of Contents
Advertisement
RDL-2000
User Manual
3.10 Spectrum Sweep
Use this feature to determine if interference is present in the selected band. When the
sweep is completed, the graph displays the average RSSI (black) and maximum RSSI
(red) RSSI measured for each channel (currently selected channel is displayed in blue).
Note: This feature is provided as a general diagnostic and troubleshooting tool only and
is not a valid test for benchmarking performance of the wireless interface.
Important: This feature will halt all data traffic on the wireless link. The RDL-2000 must
be rebooted at the end of the test period. This function should be performed only during
installation or a scheduled maintenance window.
This test can only be performed using a local connection to the RDL-2000. No user data
is transmitted over the wireless link while this test is running. This operation requires a
system reboot.
Figure 23: Link Mgr - Spectrum Sweep Screen
Start: Click this button to start scanning the selected band.
Clear: Click this button to clear the display and RSSI readings.
Stop: Click this button to stop scanning.
Save Bitmap: Save the graph as a bitmap (Windows™ .bmp) file.
Poll Interval: Adjust the slider to specify the time to scan each selected channel.
All Channels: When enabled, the unit will scan all channels in the list. To scan a single
channel, uncheck this box and check the box
adjacent to each required channel.
70-00143-01-01a
Proprietary Redline Communications © 2010
Page 35 of 50 September 24, 2010
Advertisement
Table of Contents
