Troubleshooting; Reset Text Messages; Reset Causes; Table 5: Maintenance - Reset Text - Redline RDL-2000 User Manual

4

Troubleshooting

4.1

Reset Text Messages

The following table lists causes that may be logged in the Reset Text description. This
description includes the duration of uptime (seconds) since the previous reboot.
DFS Detected
DFS Detected by SU
Link type changed
Reset text cleared by PC
Reset text corrupted
Resetting the unit to perform ACS
Scan stopped
Scanning watchdog expired
Signal lost
Telnet reset command
4.2

Reset Causes

The unit will perform a (normal) reset when the following operating parameters are
modified:
Operation
AES mode
Channel
Channel BW
DFS mode
MIMO mode
MU ID
RF Band
Fixed Frame Mode
. Operator has changed a parameter setting.
1
. Operator has loaded a new license file.
2
. DFS action has changed channel.
3
70-00143-01-01a
RDL-2000

Table 5: Maintenance - Reset Text

Master detected DFS.
Master received DFS detection message from Slave
and switched channel.
Change mode between Master/Slave.
Link Manager has sent command to clear the Reset
Text field (Action->Clear Reset Text).
The RDL-2000 has been power cycled.
User selected Perform ACS.
Spectrum sweep stopped by operator.
Slave will reboot automatically every three minutes
while in scanning mode (searching for Master).
Slave has switched to scanning mode.
Reset command from Telnet.

Table 6: Maintenance - Causes of System Reboot

Cause(s)
Operator action
Operator action
Operator action
Operator action
Operator action
Operator action
Operator action
Operator action
Proprietary Redline Communications © 2010
User Manual
Chapter
1
.
1 2
, license file , DFS action
1 2
, license file .
1 2
, license file .
1
.
1
.
1 2
, license file .
1
Page 40 of 50 September 24, 2010
4
3
.