Hyundai HYM46SPE-2 User Manual page 12

ADJUSTING THE OPC LEVER
NOTE
Before use you MUST check and if necessary adjust the Operator Presence Control
cable (OPC).
To locate the adjuster follow the cable from the OPC handle to the engine body
where you will see the OPC adjuster.
2.18 There should be 10mm play in the OPC handle before you feel resistance.
If the play is greater than 10mm the cable will need adjusting otherwise the mower
will not start.
2.19 Undo the locknut (anticlockwise) and turn the adjuster nut in a clockwise direction
until the correct amount of play has been achieved.
2.20 Attempt to start the mower and if adjusted correctly the lawnmower will start.
2.21 Tighten the locknut.
ADJUSTING THE DRIVE CABLE
2.22 There should be 10mm play in the drive handle before you feel resistance.
If the play is greater than 10mm the cable will need adjusting otherwise the mower
will have no or lose drive.
2.23 Undo the locknut on the drive cable (anticlockwise) and turn the adjuster nut in a
clockwise direction until you have the correct amount of play in the drive handle.
2.24 Check drive and if adjusted correctly the lawnmower will self-propel.
2.26 Tighten the locknut.
Lock
Adjuster
nut
nut
Lock
nut
12
Adjuster
nut