Zte MF613 User Manual page 28

Default Key: Set the WEP Key as the default.
•
WEP Keys: At most four keys can be set in the blank. Choose the primary key index. The primary key is
•
the only key in use at a given time. Whatever keys you enter for an access point, you must also enter the
same keys for the client adapter in the same order. In other words, WEP key 1 on the AP must match
WEP key 1 on the client adapter, WEP key 2 on the AP must match WEP key 2 on the client adapter,
etc. A WEP is either 10 or 26 hexadecimal digits (0~9,a~f and A~F)based on whether you select 64 bits
128 bits or 152 bits in the Encryption Strength drop-down list.
If the Authentication type is WPA-PSK , WPA2-PSK or WPA-PSK/WPA2-PSK , the WPA parameters
are shown in the following figure.
WPA Algorithm: TKIP, AES or AUTO.
•
Pass Phrase: You can input hexadecimal digits up to 64 characters or input ASCII characters choose a
•
length of 63 characters or less.
Key Renewal Interval: Define how long the key should be renewed.
•
Click Apply to confirm your configuration.
WPS
Select Wi-Fi Setting > WPS, the WPS page shown in the following figure:
WPS: This function is to simplify the security setup of Wi-Fi networks. This Router supports the
configuration setup using PIN configuration method or PBC configuration method.
Select Enable , and then click Apply to configure the details.
The following figure shows you the current configuration of WPS. Click Reset OOB on this page to
restore the default value.
28 Confidential and Proprietary Information of ZTE CORPORATION
MF613 3G Wireless Router User Manual