Ppg System Commands; Overview - PSC PT Program Generator User Manual

PPG System Commands

Overview

To use PPG to reset the default settings on the PDT, enter the human readable
portion of these bar codes at the system command prompt. This is useful to
automatically change modes for the user. The following bar codes are provided
in this section:
Additional setting bar codes are provided in the
PSC
the system command prompt in the
Figure 130. System Command Field in the Output Node
User's Guide
•
Using Predefined Defaults on page 164
•
Alternate Parameters on page 165
Falcon PT40 Product Reference Guide
Appendix D
.
.
Programming
. Enter the human readable portion at
node
Output Properties
chapter in the
dialog.
163