Error Message Table - AccuTemp Vision Touch Operator's Manual

User's manual | Vision™ Combi Steamers I 09 ERROR MESSAGE TABLE
09 I ERROR MESSAGE
TABLE
There could apear error messages on the display during the cooking process.
Their meaning is as follows:
Err 11 Chamber heating element
error.
Err 15 Failure of motor heat
protection. Signals motor
overheating above the set
limit.
Err 26 Exhaust valve error. The
automatic flap valve is not
working correctly.
Err 31 Drain heat sensor error.
Err 35 Chamber heat sensor error.
Err 36 Error of the 6-point
temperature probe.
Err 37
Thermistor disconnected.
Err 38 Thermistor short-circuited.
Err 41 Cooling error - overheating
of electronics.
Err 60-
Modbus communications
79 error.
The combi oven cannot
continue operating.
Contact an authorized
service company.
Contact your authorized
service comany.
Incorrect function of
the flap valve may affect
cooking results, however,
it is possible to continue
using the combi oven
temporarily. Contact
an authorized service
company.
The combi oven can
temporarily be used
in all modes. Contact
an authorized service
company.
Error blocks work in
all modes. Contact
an authorized service
company.
The combi oven can
temporarily be used in all
modes with the exception
of the modes with a
temperature probe. Contact
an authorized service
company.
Contact an authorized
service company.
Contact an authorized
service company.
Clean the dust filter.
If the error occurs
repeatedly, please contact
an authorized service
company.
Disconnect the power
supply to the combi oven
(not "Standby" mode), wait
30 seconds and then turn
on the combi oven again
(reconnect the power
supply). If the problem
reoccurs, please contact
an authorized service
company.
Err 80- Frequency converter error.
91
Err 95 Incorrect blower speed.
Err 96 Lighting up error.
Err 100 System error.
Equipment failures can be repaired by authorized service only, which
•
is trained and certified by the manufacturer. Warranty does not apply
in the case of improper or unauthorized service!
If the problem reoccurs,
please contact an
authorized service
company.
If the problem reoccurs,
please contact an
authorized service
company.
Check that the gas supply is
open and reattempt to start
cooking. If the problem
reoccurs, please contact
an authorized service
company.
Contact an authorized
service company.
30