Greasing The Front Wheel Bearings - Toro Workman GTX Operator's Manual

Greasing the Front Wheel
Bearings
Service Interval: Every 300 hours
Grease specification: Mobilgrease XHP™-222
Removing the Hub and Rotor
1. Lift the front of the machine and support it with
jack stands.
2. Remove the 4 lug nuts that secure the wheel
to the hub (Figure
Figure 32
1. Hub
2. Wheel
3. Remove the flange-head bolts (3/8 x 3/4 inch)
that secure the bracket for the brake assembly
to the spindle and separate the brake from the
spindle (Figure 33).
Note:
Support the brake assembly before
proceeding to the next step.
32).
3. Lug nut
1. Flange-head bolts (3/8 x
3/4 inch)
2. Spindle
4. Remove the dust cap from the hub
g033046
1. Cotter pin
2. Spindle
3. Tab washer
5. Remove the cotter pin and nut retainer from the
spindle and spindle nut
6. Remove the spindle nut from the spindle, and
separate the hub and rotor assembly from the
spindle (Figure 34
32
Figure 33
3. Caliper bracket (brake
assembly)
(Figure
Figure 34
4. Spindle nut
5. Nut retainer
6. Dust cap
(Figure 34).
and Figure 35).
g033047
34).
g192346