Using the Rear Cargo Bed
Accessory Mount
Use the rear cargo bed accessory mount to attach
accessories to the rear of the machine.
Capacity: 45 kg (100 lb)
1.
Loosen the "T" handle by rotating it clockwise
(Figure
15).
Figure 15
1. Receiver
2.
Insert your accessory into the receiver until the
holes align
(Figure
3.
Secure the assembled accessory to the receiver
tube using the clevis pin and hairpin cotter
supplied with the accessory.
4.
Tighten the "T" handle by rotating it
counterclockwise
Figure 16
1. "T" handle
2. "T" handle
15).
(Figure
16).
Performing Daily
Maintenance
Before starting the machine each day, perform
the Each Use/Daily procedures listed in
Maintenance Checklist (page
Checking the Tire Pressure
Service Interval: Before each use or daily
Front and rear tires air pressure specification: 165
to 207 kPa (24 to 30 psi)
Important:
Do not exceed the maximum air
pressure indicated on the sidewall of the tire.
Note:
The air pressure needed in the tires is
determined by the payload that you intend to carry.
1.
Check the air pressure in the tires.
•
Use lower air pressure in the tires for lighter
g034545
payloads, for less soil compaction, for a
smoother ride, and to minimize tire marks on
the ground.
•
Use higher air pressure in the tires for
carrying heavier payloads at higher speeds.
2.
If necessary, adjust the air pressure in the tires
by adding or removing air in the tires.
g034546
20
Daily
27).
Figure 17
g001055