Table of Contents
Advertisement
Deactivation
Rotate the key inserted in the lock cylinder twice towards the locking direc-
tion.
To activate the system using the remote control, press the lock button on the
remote twice
in less than five seconds.
On deactivating the "Safe" system, the alarm volumetric sensor is also deac-
tivated.
With the "Safe" switched off, doors can be opened from the interior but not
from the exterior.
See "Selective unlocking system*"
"Safe" status
On the driver's door, there is a visible light indicator which shows the "Safe"
system status.
We will know that "Safe" system is activated by the flashing light indicator.
The indicator will flash on all vehicles, fitted and nor fitted with an alarm, until
they unlock.
Remember:
Safe activated with or without alarm: Continuous Indicator flashes.
Safe deactivated without alarm: The indicator remains off.
Safe deactivated with alarm: The indicator remains off.
WARNING
No one should remain inside the vehicle if the "Safe" mechanism is acti-
vated because opening the doors will not be possible in case of emergency
neither from the inside nor the outside. Danger of death. Passengers could
become trapped inside in case of emergency.
Safety First
Operating instructions
Selective unlocking system*
This system allows to unlock either just the driver's door or all
the vehicle.
Driver's door unlock button
Unlock once. Use either the key or the remote control.
Once the key is inserted in the lock cylinder, rotate once in the unlock direc-
tion. The driver's door will remain without "Safe" and unlocked. See Anti-theft
Alarm chapter for vehicles fitted with an alarm ⇒ page 76.
Using the remote control, press the unlock button on the remote
"Safe" system for all the vehicle is deactivated, only the driver's door is
unlocked and both the alarm and the light indicator are also turned off.
Unlocking all doors and the boot
The unlock button on the remote must be pressed twice
and the boot can be opened.
Press twice within 5 seconds to deactivate the "Safe" system for all vehicle,
to unlock all doors and to use the boot. The indicator and the alarm (only vehi-
cles fitted with one) are turned off.
Unlocking the boot
See ⇒ page 79
Activating the selective unlocking system*
With the door open, insert a key into the start cylinder and start the ignition.
Insert the other key into the driver's door lock and turn in the opening direc-
tion for at least 3 seconds. The indicators will flash twice.
Deactivating the selective unlocking system*
With the door open, insert a key into the start cylinder and start the ignition.
Insert the other key into the driver's door lock and turn in the locking direction
for at least 3 seconds. The indicators will flash once.
Practical tips
Unlocking and locking
once. The
so that all doors
Technical Data
71
Advertisement
Table of Contents
