Table of Contents
Advertisement
52
Cockpit
Display with multi-function display (MFD)*
The multi-function display (MFD) shows you information on
the journey and fuel consumption.
The multi-function system uses two automatic memories: 1 - Actual
memory and 2 - Total memory. The selected memory will be shown
in the upper right-hand corner of the display.
Selecting a memory
– With the ignition switched on, briefly press button
on the windscreen wiper lever to move from one memory to
another.
Resetting a memory
– Select the memory that you would like to reset.
– Press and hold button
least 2 seconds.
Fig. 33 Windscreen wiper
lever: button A and rocker
switch B
⇒ fig. 33
A
on the windscreen wiper lever for at
A
The trip memory 1 collects the travel and consumption rates from the
moment the ignition is switched on until it is switched off. If the journey is
continued within two hours of switching off the ignition, the new values will
be added to the existing trip recorder memory. The memory will automatically
be deleted if the journey is interrupted for more than two hours.
The journey memory 2 collects the journey data for any number of individual
journeys (even if the ignition is switched off for longer than two hours) up to
a total of 99 hours and 59 minutes travel time, 9,999 km distance travelled
and 999 litres of fuel consumed. The memory will automatically be deleted if
one of the named values is reached.
Displays in the multi-function display (MFD)*
A
A
You can switch between the following displays in the multi-function display
(MFD) by operating rocker switch
Memory displays
•
Driving speed
Fig. 34 Windscreen wiper
and windscreen wash
lever: button A and rocker
switch B
⇒ fig. 34
A
on the windscreen wiper lever.
B
Advertisement
Table of Contents
