Table of Contents
Advertisement
218
If and when
– Insert the lamp holder in the indicator guide until it clicks into
place.
– First fit the indicator in the opening in the chassis, fastening the
A
⇒ page 217, fig.
tabs
1
A
⇒ page 217, fig.
by the arrow
2
Number plate light
– Insert the flat part of a screwdriver into the special slot and
remove the bulb.
– Remove the lamp holder, by turning it until it is free.
– Change the bulb.
– Replace the lamp holder, by turning it until it fits fully.
– Fit the light into the space and press until you hear a "click".
147, and then fit in the lamp as shown
147.
Interior light and front reading light
To remove the glass
– Insert a fine screwdriver between the casing and the glass
⇒ fig.
148.
– Carefully remove the glass, levering it to avoid possible damage.
To replace the lamps
– Pull the lamps outwards.
– To remove the central lamp, hold and press to one side.
Assembly
– Proceed in the reverse order, pressing gently on the outer edge
of the side light.
Fig. 148 Front reading
light
Advertisement
Table of Contents
