G-Lenz Security GDS-86208 User Manual page 21

preset position corresponds.
Clear Preset I nput preset points, click Remove button, remove the preset
：
Preset button
2 P reset Point Calls
）
In Picture 3.10, click Page Shift button, enter PTZ control interface as shown in Picture 3.12. In
the input blank, write the preset points, then click Preset button, PTZ turn to the corresponding
preset point.
Value input blank
2 C ruise between Points
、 、 、 、
Multiple preset points connected cruise lines, call cruise between points, the PTZ run around on
the line
1 C ruise Between Points Settings
）
Cruise lines is connected by multiple preset points, setting procedure is as follows:
Step1: In Picture 3.10, the Direction key will turn PTZ to designated location , click Settings
button to enter Picture 3.13,
Picture 3.11 Preset Settings
Picture 3.12 PTZ Control
Page 21
。
Preset point input blank