Sds Remote Control; Setting Sds Remote Control; Setup; Vibrate - Motorola MTP850 Feature User Manual

• On — To restore all vibrations.
• Off — To disable all vibrations.

SDS Remote Control

SDS Remote Control is a feature that enables to remotely control behavior and configuration of the radio via special
SDS messages. The messages can be sent both in TMO and DMO (including the Repeater Mode) by any radio
capable of controlling other radios. During the execution of the Remote Control messages, depending on your service
provider settings, the radio can play a tone, vibrate, or display an appropriate icon in the status icon area.
Note: This is a selling feature.

Setting SDS Remote Control

When and where to use: To enable/disable support of special SDS messages that allow remote control of the radio.
Procedure:
1 From the home screen, press the
2 Select Security → Remote Control.
3 Select On to enable, or Off to disable remote control.

Setup

This sub-menu allows you to change your radio configuration.

Vibrate

This sub-menu allows you to determine if your radio vibrates, or rings, or both vibrates and rings when receiving a
call.

Setting Default Vibrate

Procedure:
1 From the home screen, press the
2 Select Setup → Vibrate.
3 Select one of the following:
• Vibe then Ring
• Vibe Only
• Ring Only

Setting Detail Vibrate

Procedure:
1 From the home screen, press the
2 Select Setup → Vibrate → Details....
3 Select one of the following:
• Duplex Calls — Sets the vibrate settings for Phone, PABX, and Duplex Private calls.
• Simplex Calls — Sets the vibrate settings for Simplex Private Calls.
• Group Call — Sets the vibrate settings forGroup Calls.
• Messages — Sets the vibrate settings for status messages and text messages.
key.
MENU
key.
MENU
key.
MENU
Main Menu | 81
| | Send Feedback