Mounting The Cutting Blade - Stihl FCB-KM Instruction Manual

English

Mounting the Cutting Blade

Place the edger so that the blade
N
mounting (1) faces upwards
5
6
4
2
3
Insert the locking pin (2) as far as
N
possible into the bore (3), push
lightly and rotate back and forth a
little together with the thrust washer
(4) until the shaft is blocked.
Fit Allen wrench (5) onto nut (6).
N
10
Turn nut clockwise (left-hand
N
thread) and remove it.
Remove the thrust washer.
N
7
6
4
9
8
Position the blade (7) on the thrust
N
plate (8).
WARNING
The collar (arrow) must engage the hole
in the blade.
Fit the thrust washer (4) on the shaft
N
(9) and block the shaft.
Screw nut (6) counterclockwise
N
onto shaft and tighten.
WARNING
If the cup spring (10) on the nut (6)
becomes fatigued, then the nut must be
replaced!
Starting / Stopping the
Engine
Starting the engine
To start the engine, basically follow the
instructions for use for the KombiEngine
10
or basic power tool!
7
Place the machine on the ground in
N
a secure position
The blade must not touch the ground or
any other objects – risk of accident!
Assume a firm stance – possibilities:
N
standing, bending or kneeling
Press the machine firmly against
N
the ground with the left hand – do
not touch the control elements on
the control handle while doing so –
see instruction manual for the
KombiEngine or basic power tool
FCB-KM