Using Your Z1 Auto - Human Design Medical Z1 Auto System User Manual

Auto-adjusting continuous positive airway pressure system
Table of Contents

Advertisement

NOTE: The Z1 can be removed from the PowerShell by pressing the two
[ ] symbols on the sides of the PowerShell and sliding the Z1 out .
3 . The Z1 will power up and cycle through a series of startup displays .
4 . After about 10 seconds, the Z1 will enter standby mode . The display will read 0 . 0 .
(Figure 8)
NOTE: Remove the Battery from the PowerShell when the Z1 is not in
use, unless the Power Supply is plugged into the PowerShell to charge the
Battery . Otherwise the Z1 and PowerShell will drain the battery completely
within 2-3 days .

Using Your Z1 Auto

LCD Display
Ramp Progress
Fault
Reminder
Treatment Pressure Display
The current treatment pressure is shown on the LCD display . Once set, the prescribed treatment
pressure will be retained in the Z1's memory even during loss of power . For example, a treatment
pressure setting of 10 . 0 cm H
Ramp Progress &
Ramp Mode allows you to gradually acclimate to the prescribed treatment pressure . Ramp Mode
gradually increases the pressure from a low initial starting pressure to the prescribed treatment
pressure over a programmed interval of time . See "Programming Ramp Mode" .
If you program the Z1 for Ramp Mode, the Ramp Progress and Ramp Time Remaining indicators
will appear on the LCD display. For example, Figure 9 indicates that the ramp is just over half
complete, with a ramp time remaining of 10 minutes .
Battery Status Display
This icon is displayed when the optional PowerShell and Battery are connected . The level of
charge remaining on the Battery is indicated by the number of solid bars in the icon . The bars
flash when the Battery is charging . For example, the icon shown in Figure 9 indicates that the
Battery has between 25-50% of charge remaining . Make sure the Battery is fully charged before
each use .
General Status Display
O is displayed in Figure 9 .
2
Ramp Time Remaining Indicators
Battery Status Display (PowerShell Only)
Figure 9
AC Power Indicator
Ramp Time
Remaining
Treatment Pressure
Display
13

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Z1 Auto System and is the answer not in the manual?

Subscribe to Our Youtube Channel

Related Products for Human Design Medical Z1 Auto System

Table of Contents

Save PDF