Installing / Replacing Batteries - Baracoda TagRunners User Manual

Installing / replacing batteries

Only use Baracoda approved rechargeable batteries. The use of any other batteries may damage the reader
and void the warranty. Please remove the batteries when you are storing the reader for more than 30 days.
To insert batteries into TagRunners:
1. Use a coin or your finger to unlock and remove the battery cover at the back of the
TagRunners. Turn the lock underneath the reader to a horizontal position.
2. Insert the battery lid downwards.
3. Plug the small battery cable into the battery connector (Zone A in Fig. 2).
4. Insert the Baracoda Battery in its location. Pay attention also to well position the
battery connector.
5. Slide the cover up and lock it into place.
Caution. Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the
instructions.
Switching on the reader
Remember to fully charge the battery before first use.
In order to switch on the reader, please press the trigger button.
The reader will switch off after some period of inactivity. The default time period is ten (10) minutes of reader
inactivity if the device is not connected via Bluetooth. This default value can be modified by the end user.
Baracoda TagRunners – User Guide v1.6
Data Capture
for Workforce
in Motion
A
Fig. 2
- 8 -