Pda Stylus - Baracoda TagRunners User Manual

PDA stylus

In order to attach the PDA stylus to the TagRunners, insert the stylus into the hole, as showed in Fig.1. Note
that there are two holes, symmetric around the principal axe of TagRunners. Push downwards, as shown by the
arrow n° 2 in Fig.1 till you will hear a clips.
There are two holes, one on both sides.
Note: You will not be able to use the Protective boot and the PDA stylus simultaneously.
Recharging the battery
Recharge the internal battery by using the included AC adapter or the charging cradle (optional). The Adapter
rating is 5V, 500mA.
When the scanner is charging, the RSL led (left) has the following status: one single long blink red + green
(solid).
When the scanner is fully charged, the RSL led (left) is green (solid).
A full recharge (from completely drained batteries) takes approximately four (4) hours.
When the original batteries wear out, please contact your Baracoda reseller for replacements.
Note: When you insert the TagRunners (with its protective boot) in its charging cradle, the reader will:
- emit a beep.
- and automatically switch on (if it was off).
Baracoda TagRunners – User Guide v1.6
1
2
Fig.1
Data Capture
for Workforce
in Motion
- 7 -