Rfid P Rotocol I Dentifier - Baracoda TagRunners User Manual

RFID Protocol Identifier
The reader can transmit a maximum of 3 (three) digit RFID Protocol Identifier codes for different types of RFID
protocols. You can activate RFID Protocol Identifier through BaracodaManager software (v3.35 min). The RFID
Protocol Identifier is disabled in default settings.
If the option is selected, the RFID Protocol Identifier is added at the beginning of the data frame.
List of RFID Protocol Identifier codes can be found in the following table:
Identifier
[A]
[B]
[C]
[D]
[E]
[F]
[G]
[H]
[I]
[Z]
Beeps and LEDs
You can enable/disable Beeps / LED Lightening with the BaracodaManager software (v3.35 min).
Power management
Mutliple parameters exist to optimize the battery autonomy ("Sniff period", "Shutdown timer", etc...)
TagRunners is configured at 20dBm (Bluetooth Class.1) by default.
The BaracodaManager software (v3.35 min) can be used for multiple setting changes.
Low battery
An alternation of red and green blinking on the two (2) LEDs indicates that the battery level is low. Recharge
battery immediately. If you continue using the reader, it will continue working until a triple beep occurs: at that
moment the reader will shut down and you will be forced to charge it.
Baracoda TagRunners – User Guide v1.6
Associated RFID protocol
ISO/IEC 14443-A (or NXP Mifare)
ISO/IEC 14443-B
ISO/IEC 15693 (e.g. TI Tag-it or NXP ICODE-SLI)
NXP ICODE-1
Inside Contactless PicoTAG
S.T. MicroElectronics SR
ASK CTS256B/CTS512B
Calypso (Innovatron protocol)
EPC HF Version 2
Unknown
Data Capture
for Workforce
in Motion
- 11 -