How To Remove The Electrical Parts - Mitsubishi Electric EHSE-YM9EC Service Manual

DISASSEMBLY PROCEDURE

3. How to remove the electrical parts

(Steps (1) through (3) are applied to all the following parts.)
(1) R emove the front panel. (Refer to Procedure 1).
(2) R emove the 3 screws holding the control box. (Photo
3-1)
(3) S lightly lift and pull out the control box. (Photo 3-1)
<Earth leakage circuit breaker> (Photo 3-2)
(4) D isconnect all the lead wires from the earth leakage cir-
cuit breaker.
(5) R emove the 2 screws on the earth leakage circuit break-
er.
Note: T o avoid dropping of the breaker, hold the breaker by
hand when removing the last screws.
<Contactor> (Photo 3-2)
(4) Disconnect all the lead wires from the contactors.
(5) Remove the 2 screws on each contactor.
Note: To avoid dropping of the contactors, hold the contac-
tors by hand when removing the last screws.
To prevent an electrical shock, wait until all the LED
lamps on the FTC control board are turned off.
<Terminal block> (Photo 3-2)
(4) D isconnect all the lead wires from the terminal block. (To
disconnect the S1, S2 and S3 lead wires, disengage the
locks by pressing on the claws.)
(5) Remove the screw on the terminal block.
Note: T o avoid dropping of the terminal block, hold the termi-
nal block by hand when removing the screw.
<Controller board> (Photo 3-3)
(4) Disconnect all the lead wires from the controller board.
(5) Remove the controller board from the 4 board supports.
OCH590B
PHOTOS
Photo 3-1
Control box fixing screws
Photo 3-2
Earth leakage circuit
breaker (ECB1)
Screws
Contactors
Screw
Note: The photos shown are of the E*SE-YM9EC model.
Photo 3-3
Controller
board
58
Controller
Control box
board
Terminal block (TB1)
Board supports
Board supports