•
Wired
•
Network proxy
Figure 3. Network Settings page
Configuring wired network connection settings
To configure the wired connection settings, perform the following steps:
1
Click the Wired tab. The following attributes are displayed if the network cable is connected to your thin client and wired connection is
established.
•
IP Address
•
Hardware Address
•
Default Route
•
DNS
NOTE:
After the network is disconnected, only hardware address and last used information are displayed.
2
On the lower-right corner of the page, click the Settings icon to configure the Wired Network connections.
a
In the Details tab, the following attributes are displayed.
•
IP Address
•
Link Speed
•
Hardware Address
•
Default Route
•
DNS
3
Click the Security tab to configure the 802.1x security settings.
a
Click the ON button to enable the 802.1x Security for your network connection.
b From the Authentication drop-down list, select the type of authentication you want to set for your network connection. The
available options are:
•
MDS
•
TLS
•
FAST
•
Tunneled TLS
•
Protected EAP (PEAP)
c
If the authentication type is selected as MD5, you must configure the following options.
Networks
17