Advertisement
d Enter the IP address of the WINS Server in the WINS Server box.
Use of WINS is optional. Enter the network address of an available WINS name server. WINS allows you to specify remote
systems by their host names rather than IP addresses. If a specific IP address (instead of a name) is entered for a connection, it
is used to make the connection. These entries can be supplied through DHCP, if DHCP is used. DNS and WINS provide
essentially the same function, name resolution. If both DNS and WINS are available, the thin client attempts to resolve the name
using DNS first and then WINS.
You can enter two WINS Server addresses (primary and secondary), separated by a semicolon, comma, or space.
e
Enter the digit multiplier of 30 seconds in the TCP Timeout box to set the time-out value of a TCP connection. The value must
be 1 or 2 which means the connection time-out value is from 1x30= 30 seconds to 2x30= 60 seconds. If the data for connecting
to the server is not acknowledged and the connection is time out, setting the time-out period retransmits the sent data and
again tries to connect to the server until the connection is established.
3
Click OK to save the settings.
Configuring the DHCP Options Settings
To configure the options settings:
1
From the desktop menu, click System Setup, and then click Network Setup.
The Network Setup dialog box is displayed.
2
Click the Options tab, and use the following guidelines:
a
DHCP Option IDs — Enter the supported DHCP options. Each value can only be used once and must be between 128 and 254.
b Interpret DHCP Vendor-Specific Info — Select this check box for automatic interpretation of the vendor information.
c
DHCP Vendor ID — Shows the DHCP Vendor ID when the dynamically allocated over DHCP/BOOTP option is selected.
d DHCP UserClass ID — Shows the DHCP UserClass ID when the dynamically allocated over DHCP/BOOTP option is selected.
3
Click OK to save the settings.
12
Networks
Advertisement
