Advertisement
g PEAP—If you select the PEAP option, click Properties to open and configure the Authentication Properties dialog box. Be
sure to select either EAP_GTC or EAP_MSCHAPv2, and then use the correct Username, Password, and Domain. Validate
Server Certificate is optional.
NOTE:
The server certificate text box for LEAP and PEAP supports a maximum of approximately 127 characters, and supports
multiple server names.
h To configure the EAP-GTC, enter the username only. The password or PIN is required when authenticating.
To configure EAP-MSCHAPv2, enter the username, password, and domain.
IMPORTANT:
The CA certificate must be installed on the thin client, and the server certificate is forced to be validated. When EAP-
MSCCHAPV2 is selected in EAP type in the Authentication Properties dialog box (for PEEP IEEE802.1x authentication), an
option to hide the domain is available for selection. Username and Password boxes are available for use, but the Domain text box
is disabled.
3
Click OK to save the settings.
Configuring the WLAN Settings
1
From the desktop menu, click System Setup, and then click Network Setup.
The Network Setup dialog box is displayed.
2
Click the WLAN tab, and use the following guidelines:
a
Add— Use this option to add and configure a new SSID connection.
You can configure the SSID connection from the available security type options.
The domain/username in the username box is supported, but you must leave the domain box blank.
Networks
15
Advertisement
